Cisco terminal emulator for mac series#

Step 3 вЂ“ OPTIONAL вЂ“ If your image is corrupted you can format your flash file system by executing the format flash: command as shown below however this will delete your start-up configuration!!!ДЄre you sure you want to format 'flash:' (all data will be lost) (y/n)?yДЇlashfs: flashfs fsck took 12 seconds. Once youвЂ™ve booted into Switch ROM mode youвЂ™ll need to initialize the flash file system by executing the flash_init command as shown below ДЇlashfs: 0 orphaned files, 0 orphaned directoriesДЇlashfs: flashfs fsck took 10 seconds. The flash filesystem, and finish loading the operating The system has been interrupted prior to initializing theДЇlash filesystem. The password-recovery mechanism is enabled.

Once youвЂ™ve booted your switch into Switch ROM mode youвЂ™ll be see the following dispatch Д«oot Sector Filesystem (bs) installed, fsid: 2Д«ase ethernet MAC Address: 00:14:f2:d2:41:80 You can check out the required procedure by clicking HERE! This typically involves holding down the STAT button on the front of the switch when plugging in the power.

Cisco terminal emulator for mac series#

Unfortunately fixed configuration switches require the use of xModem to restore a corrupt or missing IOS images unlike the Cisco 4500 and Cisco 6500 Series supervisor engines which use compact flash cards Recovering the Cisco IOS Image on a fix configuration Cisco Catalyst Series Switch is quite a bit different and more of an вЂњold schoolвЂќ way of doing an IOS image recovery.

Boot the switch and verify that the switch boots properly.

Unset the baud so that it defaults back to 9600.

Set the boot parameter to the new image name located in Flash:.

Copy the Cisco IOS Image via xModem to Flash:.

Set the baud rate to 115200 to increase xmodem transfer speed and decrease time required to restore the IOS Image.

(This will remove your startup configuration)

OPTIONAL вЂ“ Format the flash file system if needed.